| 加工定制：是 | 品牌：LUTRON/路昌 | 型号：CPC-PCIe |
| 产品用途：接口转换 | 规格：CPC-PCIe |
CPC-PCIe德国ems公司can卡Thomas Wunsche
Passive CAN interface for PCIe x1 slots
One, two or four CAN controllers NXP SJA1000
Optional galvanic separation of CAN controller to PC
Optional galvanic separation between CAN channels
Supports 11 bit frames and 29 bit frames
Development kits for Windows 2000/XP/Vista/7/8 and Linux available
CPC-PCIe is a passive CAN plug-in board for PCIe x1 slots. CPC-PCIe was designed for industrial series application and has a robust and cost efficient construction. CPC-PCIe supports either one, two or four CAN channels that can be operated independantly with different data rates. The interface comes with the NXP CAN controller SJA1000, that offers good diagnostic attributes. CPC-PCIe maps the CAN controller(s) directly in the address space of the PC and allows access of the CAN messages with low latencies. Existing software for the supported CAN controller can easily be adapted. The CAN communication with CPC-PCIe may be handled either in interrupt controlled mode or in polled mode, interrupt channels are assigned automatically (Plug & Play). Optionally, CPC-PCIe is available with galvanic separation between PC and CAN bus. A galvanic separation between the CAN channels is also possible by separate DC/DC converters.
| Pin assignment | Connector D-Sub 9, complying to CiA DS-102 |
| Type of the physical connection | *** 11898 / Transceiver PCA82C251 |
| Maximum voltage on bus pins | ±30V refering to bus ground |
| ***lation volatage with galvanic separation | ±1000V DC |
| Ressource | Parameter |
| PC address space | Automatic Assignment (Plug & Play) |
| Interrupt | Automatic Assignment (Plug & Play) |
Configuration and CAN communication with CPC-PCIe are done by accesses to the memory address area of the PC. The appropriate data areas are mapped by CPC-PCIe and ?plug&play” software into the memory address space. Due to the direct access to the CAN controllers the CAN communication takes place with low latency time The memory used by CPC-PCIe is divided in several sections. The control registers allow the detection of the interface type similiar to the interfaces CPC-Card, CPC-XT and CPC- 104 and the generation of hardware resets for the CAN controllers. The access to the CAN controllers occurs via a separate memory space for each interface. In these memory spaces, the sending and receiving buffers as well as the control registers of the CAN controller are accessible. A specification describing the access of the CAN controllers and drivers for Windows and Linux are available separately.
Plug In board CPC-PCIe
User Manual
proCANtool CAN-Monitor for operating system Windows 2000/XP/Vista/7/8
