| 品牌：德国peak | 型号：PCAN-Repeater | 中继距离：0.5Km |
| 设备类型：中继器 | 传输介质：线缆 | 电源要求：无 |
| 雷击保护：有雷击保护 | OEM：不可OEM |
PCAN-Repeater DR货号IPEH-004038德国peak品牌can中继器
The PCAN-Repeater DR establishes a connection between two High-speed CAN busses with galvanic ***lation of up to 5 kV. Both CAN channels are decoupled from each other and from the power supply. All message traffic including error frames is forwarded 1:1 between both channels, if necessary, in one direction only. The PCAN-Repeater DR behaves passively and is transparent from the perspective of the CAN bus. LEDs display the current bus status. With its DIN rail casing and extended temperature range support, this module is suitable for use in an industrial environment.
Due to the CAN protocol, the maximum length of a CAN bus depends on the bit rate. Therefore, a bus cannot be extended with the PCAN-Repeater DR.
The physical total length of the CAN bus is reduced with each built-in PCAN-Repeater DR according to its signal delay.
Two High-speed CAN channels (*** 11898-2)
Galvanic ***lation rated up to 5 kV according to IEC60601-1, between both CAN channels and between CAN and power supply
Bit rates from 5 kbit/s up to 1 Mbit/s
Compliant with CAN specification 2.0A (11-bit ID) and 2.0B (29-bit ID)
NXP PCA82C251 CAN transceiver
Connections for CAN and power supply via 4-pin screw terminal block (Phoenix)
LEDs display CAN bus load and CAN errors
Each CAN channel can be selectively terminated
Listen-only mode for CAN channel 1 or CAN channel 2 can be switched selectively
Plastic casing (width: 22.5 mm) for mounting on a DIN rail (DIN EN 60715 TH35)
Voltage supply from 8 to 30 V
Extended operating temperature range from -40 to 85 °C (-40 to 185 °F)
PCAN-Repeater DR in DIN rail plastic casing
3 mating connectors for power supply and CAN connections
Manual in PDF format
