| 加工定制：是 | 品牌：Rosemount/罗斯蒙特 | 型号：CANopen-DP |
| 用途：canopen设备连接到SIEMENS SIMATIC-S7 | 产品认证：PNO |
profibus-dp转canopen网关CANopen-DP德国esd公司生产
DP-slave with 240 bytes input and 240 bytes output PROFIBUS data
CANopen Manager
Cycle time only limited by PROFIBUS
Application example: SIEMENS SIMATIC-S7 to CANopen
Run-time configuration via PLC
No special tools required
Plug &＃39;n&＃39; play replacement
The module CANopen-DP can link any PROFIBUS-DP master to a CANopen network. The gateway operates as a PROFIBUS-DP slave-I/O component with a total of maximum 244 bytes input and 244 bytes output data. It supports cyclic (DP-V0) as well as acyclic (DP-V1) PROFIBUS data transfers. On CANopen it operates as a CANopen manager supporting CANopen master, NMT master and configuration functions. PDO and SDO (with SDO timeout and MPDO transmission) data transfers are supported. START frame, SYNC and Heartbeat are controlled by the module.
With the CANopen-DP gateway you can couple CANopen modules to e.g. a SIMATIC-S7. The number of CANopen devices is not limited by the module.
The *** 11898-compatible CAN interface allows a maximum data-transfer rate of 1 Mbit/s. The PROFIBUS-DP-Slave interface automatically recognizes all usual bit rates up to 12 Mbit/s. The PROFIBUS-DP as well as the CAN interface are electrically ***lated.
The module can be configured via PROFIBUS configuration tool, e.g. the PLC SIMATIC Manager. CANopen is supported as CAN-layer-7 protocol on the CAN layer. Additionally CAN-layer-2 functions are available.
